Connecting Directly To The Projector - Sony VPH-D50Q Manuel D'installation

Connecting Directly to the Projector

When multiple input sources are connected to the projector
TRIGGER
IN OUT
RS-422A
PLUG IN POWER
CONTROL S
REMOTE
Color monitor
Video equipment
26
(EN) Connections
You can expand the system connections by using the IFB-40 Signal
Interface Board which is installed to the projector by default, or in
combination shown in the examples below.
Use the IFU-1271/1271M Signal Interface Unit.
Rear
IN OUT
ABL LINK Y IN
OUT
IN IN
INDEX VIDEO S VIDEO
to video input
to video output
to S Video output
Setting up
• Set INPUT-A in the SET SETTING menu to RGB.
For details, see "The SET SETTING Menu" on page 50 (EN).
• Select VIDEO or S VIDEO by pressing the INPUT SELECT keys on the
remote control or by setting VIDEO in the INPUT SELECT menu.
For details, see "The INPUT SELECT Menu" on page 44 (EN).
• Switch the 75-ohm terminate connectors according to the connections of
the computer and color monitor.
For details, see "Switching the 75-ohm Terminate Connectors" on page 24 (EN).
C IN
R G B SYNC/HD VD
REMOTE1
OUT
R-Y/P Y B-Y/P
R B
INPUT A IN
to RGB output
IFU-1271/1271M
to RGB
input
IFB-12
to RGB Input
to RGB output
SMF-401, etc.
MODE
OUT
Color monitor
Computer