The Input Setting Menu - Sony VPH-D50Q Manuel D'installation

The INPUT SETTING Menu

The INPUT SETTING menu is used to adjust the
input signal.
Items that can be adjusted are displayed in green.
You cannot select the items indicated in white.
Page 1
C O L O R T E M P : 6 5 0 0
INPUT
SELECT
C L A M P : A U T O
V S H I F T : W I D E
PIC
CTRL
S Y N C S E L : A U T O
C O M P O N E N T F O R M A T :
INPUT
SETTING
S M P T E / E B U - N 1 0
S Y N C O S C : 1
SET
SETTING
INPUT
INFO.
SEL: SET: ENTER
Page 2
R G B S I Z E
INPUT
SELECT
R G B S H I F T
B L K G
PIC
CTRL
INPUT
SETTING
SET
SETTING
INPUT
INFO.
SEL: SET:
ENTER
I N P U T - A
EXIT: MENU
I N P U T - A
EXIT: MENU
COLOR TEMP (Temperature)
Selects the appropriate color temperature according to
your application and the input source signal.
C O L O R T E M P 9 3 0 0
INPUT
SELECT C L A M P : A U T O 6 5 0 0
V S H I F T : W I 5 4 0 0
PIC/AU
CTRL S Y N C S E L : A 3 2 0 0
C O M P O N E N T P R E S E T
INPUT
SETTING S M P T E
S Y N C O S C : 1
SET
SETTING
INPUT
INFO.
SEL: SET: ENTER EXIT: MENU
If you wish to make the color of a particular input
signal uniform to that of a color monitor, select
PRESET, then adjust the white balance.
For details, see "Adjusting the White Balance" on page 96
(EN).
CLAMP
Corrects the luminance of the input picture.
I N P U T - A
C O L O R
INPUT
SELECT C L A M P A U T O
V S H I S o n G
PIC/AU
CTRL S Y N C H / C
C O M P O H P
INPUT
SETTING T R I - L E V E L S
S Y N C
SET
SETTING
INPUT
INFO.
SEL: SET: ENTER EXIT: MENU
CLAMP is used as a standard for setting the black
level of a picture correctly. The standard position of the
clamp depends on the kind of sync signal being used.
Normally, the projector CPU judges the signal and sets
the position automatically. However, the CPU can
misjudge the signal because of noise. If the luminance
of the picture seems to be incorrect, the clamp position
may need to be changed.
AUTO: Automatic setting mode. Normally set to this
position.
SonG: Set to this position if the black seems too light
or greenish.
H/C: Set to this position if the picture is too dark or
luminance is unstable.
HP: If the luminance is still incorrect after changing
to the SonG or H/C position, set to this position
and perform the H-SHIFT adjustment.
TRI-LEVEL S: Set to this position if the picture is
dark when using the tri-level sync.
Note
If the luminance is still incorrect after changing the clamp
setting, check the input signal and the connections.
47
Before adjustment (EN)