Sony VPH-D50Q Manuel D'installation page 28

Using the Signal Interface Switcher
When the switcher is connected to the projector using both the SIC-M or CCQ-BRS
connecting cable and the 5BNC cables (5BNC mode 1)
TRIGGER
IN OUT
RS-422A
PLUG IN POWER
CONTROL S REMOTE
Video equipment
28
(EN) Connections
When you connect both the video and RGB signal input sources to the
switcher, use the SIC-M or CCQ-BRS connecting cable and the BNC
cables for connection between the projector and switcher.
Rear
IN OUT
ABL LINK Y IN
IN OUT IN
INDEX VIDEO S VIDEO
to video output
to S video output
Video
equipment
Notes
• Insert the female and male plugs of the SIC-M or CCQ-BRS cable correctly.
• You can extend the SIC-M or CCQ-BRS cable up to 50 m.
• The video signal input to the signal interface board installed to the INPUT B
section should not exceed 70 MHz. When projecting the video signal which
exceeds 70 MHz, connect the signal source to the INPUT A connectors using the
5BNC cables.
Setting up
• Set INPUT-A to RGB and 5BNC MODE to ON in the SET SETTING
menu.
For details, see "The SET SETTING Menu" on page 50 (EN).
• Select VIDEO or S VIDEO by pressing the INPUT SELECT keys on the
remote control or by setting VIDEO in the INPUT SELECT menu.
For details, see "The INPUT SELECT Menu" on page 44 (EN).
• Set the SINGLE/SECOND/OTHER select switch on the switcher to
SINGLE.
IFB-40 Signal Interface Board
C IN
R G B SYNC/HD VD
REMOTE1
OUT R-Y/P Y B-Y/P
R B
INPUT A IN
5BNC cables
PC-1271/1271M
Switcher
to MONITOR OUT
HDTV/
Component Computer
equipment
MODE
OUT
IN
SIC-M or CCQ-BRS
connecting cable
to REMOTE 1 OUT
Computer