Adjusting The Registration; Procedure - Sony VPH-D50Q Manuel D'installation

Adjusting the Registration

Adjusting the Registration

Procedure

68
(EN) Adjustments
1 Mark the center of the screen.
v
2 Set the remote control to the service adjustment mode.
(page 37 (EN))
v
3 Select NO INPUT mode.
v
4 Select the internal oscillation pattern to be used for the registration
adjustment.
(page 69 (EN))
v
5 Reset the registration data to the factory preset levels. (Only if the
adjustment data has been modified before)
v
6 Adjust the green registration.
1 CENT adjustment
2 SIZE and LIN adjustments
3 SKEW and BOW adjustments
4 KEY and PIN adjustments
5 KEY BALANCE and PIN BALANCE adjustments
v
7 Adjust the red registration.
1 CENT adjustment
2 SIZE and LIN adjustments
3 SKEW and BOW adjustments
4 KEY and PIN adjustments
5 KEY BALANCE and PIN BALANCE adjustments
6 ZONE adjustment
v
8 Adjust the blue registration.
1 CENT adjustment
2 SIZE and LIN adjustments
3 SKEW and BOW adjustments
4 KEY and PIN adjustments
5 KEY BALANCE and PIN BALANCE adjustments
6 ZONE adjustment
v
9 Save the adjusted data as the standard data.
v
!º Adjust fine for each input signal.
1 Adjustment of video input signal
2 Adjustment of RGB input signal
3 White balance adjustment
v
!¡ Activate the protection of the remote control.
v
!™ Adjust the picture.
(page 103 (EN))
v
Complete
(page 69 (EN))
(page 69 (EN))
(page 100 (EN))
(pages 71 (EN) to 79 (EN))
(pages 80 (EN) to 88 (EN))
(page 89 (EN))
(page 90 (EN))
(pages 91 (EN) to 97 (EN))
(page 102 (EN))