Adjusting The Registration; Procedure - Sony VPH-G70Q Manuel D'installation

Adjusting the Registration

Procedure

1 Mark the center of the screen.
v
2 Set the remote control to the service adjustment mode.
(page 38 (EN))
v
3 Select NO INPUT mode.
v
4 Select the internal oscillation pattern to be used for the registration
adjustment.
(page 74 (EN))
v
5 Reset the registration data to the factory preset levels. (Only if the
adjustment data has been modified before)
v
6 Adjust the green registration.
1 CENT adjustment
2 SIZE and LIN adjustments
3 SKEW and BOW adjustments
4 KEY and PIN adjustments
5 KEY BALANCE and PIN BALANCE adjustments
v
7 Adjust the red registration.
1 CENT adjustment
2 SIZE and LIN adjustments
3 SKEW and BOW adjustments
4 KEY and PIN adjustments
5 KEY BALANCE and PIN BALANCE adjustments
6 ZONE adjustment
v
8 Adjust the blue registration.
1 CENT adjustment
2 SIZE and LIN adjustments
3 SKEW and BOW adjustments
4 KEY and PIN adjustments
5 KEY BALANCE and PIN BALANCE adjustments
6 ZONE adjustment
v
9 Save the adjusted data as the standard data.
v
!º Adjust fine for each input signal.
1 Adjustment of video input signal
2 Adjustment of RGB input signal
3 White balance adjustment
v
!¡ Activate the protection of the remote control.
v
!™ Adjust the picture.
(page 110 (EN))
v
Complete
(page 74 (EN))
(page 74 (EN))
(page 108 (EN))
(pages 76 (EN) to 84 (EN))
(pages 85 (EN) to 93 (EN))
(page 94 (EN))
(page 95 (EN))
(pages 96 (EN) to 104 (EN))
(page 109(EN))
73
Adjustments (EN)