Sony VPH-G70Q Manuel D'installation page 24

Location and Function of Connectors
5 RS-422A REMOTE connector (D-sub 9-pin)
Used to expand the system connections using the RS-
422A interface.
Before using the connector, loosen the two screws to
remove the cap.
6 VIDEO IN/OUT connectors
VIDEO IN connector (BNC type): Connects to the
composite video output of the video equipment.
VIDEO OUT connector (BNC type): Connects to
the composite video input of a color monitor.
7 ABL (Automatic Brightness Limiter) LINK IN/
OUT jacks (minijack)
When connecting multiple projectors, connects the
ABL LINK OUT jack to the ABL LINK IN jack on
another projector. You can synchronize the brightness
limiting point among the projectors, allowing to make
the whole screen brightness uniform.
8 CONTROL S jacks
IN/PLUG IN POWER (5 V) jack (stereo
minijack): Connects to the CONTROL S OUT
jack of other Sony equipment. Also connects to the
CONTROL S OUT jack of the supplied remote
control with the supplied remote control cable
(stereo cable) to be used as a wired remote control.
In this case, this jack supplys 5 V to the remote
control as power source.
OUT jack (stereo minijack): Connects to the
CONTROL S IN jack of other Sony equipment.
Note
When using this jack, the remote control detector on the
projector does not function.
9 INDEX NO. switches
When multiple projectors are connected, set the index
number of each projector.
To display the index number on the screen, press the
NORMAL key, and the ENTER key on the remote
control.
Note
If you set the index number to "00," the projector does not
operate.
!º AC IN socket
Connect the supplied AC power cord.
!¡ MAIN POWER switch
24
(EN) Connections