Adjusting The Rgb Input Signal - Sony VPH-G70Q Manuel D'installation

Fine Adjustment for Each Input Signal

Adjusting the RGB Input Signal

Fine magnetic focus and AQP/DQP adjustments
Fine registration adjustment
100
(EN) Adjustments
1
Connect an RGB signal to the RGB IN connectors on the INPUT A or
on the signal interface board installed to the INPUT B section.
2
Press the INPUT SELECT A or B key on the remote control to select
the RGB input signal.
3
Adjust the magnetic focus and AQP/DQP.
For details, see "Adjusting the green magnetic focus and AQP/DQP" on page
68 (EN).
4
Fine adjust the registration if necessary.
For details, see "Adjusting the Registration" on pages 73 (EN) to 94 (EN).
1
Press the PATTERN key to display the 9 × 9 DOT pattern.
2
If necessary, fine adjust the magnetic focus, AQP and DQP.
For details, see "Adjusting the green magnetic focus and AQP/DQP" on page
68 (EN).
3
Press and release the MEMORY key to save the adjustment data.
1
Press the PATTERN key to display the CROSS HAIR pattern.
2
If necessary, fine adjust the registration.
For details, see "Adjusting the Registration" on pages 73 (EN) to 94 (EN).
3
When you connect two or more RGB input sources, fine adjust the
registration for each input signal.
4
Press the MEMORY key and release it to save the adjustment data.