The Set Info (Information) Menu - Sony VPH-G70Q Manuel D'installation

Using the MENU
POWER ON DELAY
When connecting multiple projectors, set to ON to turn
on the projectors sequencially one by one.
S
I
P O W E R O N D E L A O N
SERVICE
SETTING P I C . O R B I T I N G : O F F
A L L W H I T E M O D
SET
INFO. 2 0 m i n
UNI
FORMITY
ABL
LINK
SEL: SET:
ENTER EXIT: MENU
PIC. (picture) ORBITING
Set to ON to activate the function which shifts the
picture slightly to reduce CRT burn.
S
I N P U T - A
P O W E R O N D E L A
SERVICE
SETTING P I C . O R B I T I N G : O N
A L L W H I T E M O D O F F
SET
INFO. 2 0 m i n
UNI
FORMITY
ABL
LINK
SEL: SET: ENTER
EXIT: MENU
ALL WHITE MODE
Sets the duration of all white mode during a warm-up
period.
A L L W H I T E M O D E : 2 0 m l n
Use the V, v, B or b key to set the duration in 1 minute
increments from 0 to 99 minutes.
To set the projector to display the picture immediately
after the projector is turned on, set the duration to "0
min."
For details, see "Changing the Initialization Period" on
page 111 (EN).
56
(EN) Before adjustment

The SET INFO (information) Menu

The SET INFO menu displays the information on the
projector such as the serial number, a ROM version,
the use time of the projector.
S
S E R . N o . : X X X X X X X
SERVICE
SETTING
R O M V E R .
SET
INFO. M : 1 . 0 0 S 1 : 1 . 0 0
S 2 : 1 . 0 0 S 3 : 1 . 0 0
UNI
FORMITY
T I M E R
ABL
LINK
SEL: SET:
ENTER
SER. (serial) No.
Indicates the serial number of the projector.
ROM VER. (version)
Indicates the ROM version (M, S1, S2 and S3) used
for the projector.
TIMER
Indicates the use time of the projector and that of each
CRT.
O P E R A T I O N T I M E R
0 0 0 0 1 H R S
C R T T I M E R :
R : 0 0 0 1 H R S
G : 0 0 0 1 H R S
B : 0 0 0 1 H R S
RESET: RESET
SEL: SET: SET:
ENTER ENTER EXIT: MENU
OPERATION TIMER: Indicates the total use time
of the projector.
CRT TIMER: Indicates the use time of the red,
green and blue CRTs, respectively.
I N P U T - A
EXIT: MENU