Projecting; Turning On The Projector - Sony CPJ-D500 Mode D'emploi

Projecting

If the bulb does not
light up
If you press POWER
again just after turning
it off, the bulb will not
light up. This is because
of the characteristics of
the bulb and is not a
malfunction. In this
case, wait for a while
and press POWER
again. The bulb will
light up.
Notes
• Wait until the
projector is warmed
up. It will take about
one minute until the
projected plane
appears.
• Do not press POWER
while the LAMP
indicator is flashing.
Doing so will cause
malfunction of the
unit.
12
-EN Projecting
FOCUS
LOCK
Front stand

Turning on the projector

1
Press POWER of the control panel.
The ON/STANDBY indicator turns green. The
LAMP indicator starts flashing.
The bulb lights up and the projected plane appears.
2
If necessary, adjust the position of the projected
plane using the stand.
1 Unlock the stand.
2 Adjust the position.
3 Lock the stand securely so that the stand does
not collapse.
You can adjust the horizontal balance by
turning the spacer.
ON/STANDBY LAMP
POWER PC/VIDEO
FUNCTION
VOL
FUNCTION RESET COUNT DOWN
SET START
Control panel
Side stands
Spacer