Publicité
Presets
IR Loader block
The IR loader makes much easier to use your own or third-party
Impulse Responses. Single and Double IR Loaders are available.
•
BYPASS BUTTON: Tap to activate/deactivate the impulse.
•
PHASE BUTTON: Inverts the phase of the loaded impulse.
•
LEVEL KNOB: Controls the volume of the selected impulse.
•
HI & LOW PASS KNOBS: Control the frequency range of the high
and low-pass filters, accordingly.
•
PAN KNOB (Single): Controls the output panning of the impulse.
•
BALANCE KNOB (Dual): Controls the output balance of the
selected impulse.
•
DELAY KNOB: Delays the selected impulse up to 25 ms.
•
ROOM MIX KNOB: Adjusts the amount of room reverb effect that
us added to the signal.
•
PRE DELAY KNOB: Delays the reverb's first reflection up to 100
ms.
•
REV HIGH & LOW PASS KNOBS: Control the frequency range of
the reverb's high and low-pass filters, accordingly.
•
SIZE SWITCH: Sets the size of the room reverb.
•
GLOBAL OUTPUT KNOB (Dual): IR Loader block master
Tap the arrows to navigate
through the stored IRs. You
can also rotate the top-right
footswitch to cycle through
available IRs.
Tap the Quad Cortex icon to the
right of the Impulse Response
sections to control which IR
is replaced when rotating
the footswitch. The active
section shows a brighter Quad
Cortex icon with a highlighted
footswitch.
output.v
40
Publicité
