Publicité
8.
SPEED CONTROL
8.1
The Main Air Cylinder drives the cartridge kit up and down. The
stroke speed of the Main Air Cylinder can be adjusted by rotating the
flow control screw (Fig. 14.0) counterclockwise to increase the speed
and clockwise to decrease the speed.
8.2
The Injection Rod Air Cylinder drives the Injection Rod up and down.
The injection speed can be adjusted by rotating the flow control screw
(Fig. 14.0) counterclockwise to increase the speed and clockwise to
decrease the speed.
NOTE: For TS6500CIM-SMR-6 and TS6500CIM-SMR-20 models, the
injection rod flow control is shut-off from the factory. To re-activate
the injection rod, slowly turn the flow control screw counterclockwise
until the desired speed is achieved.
MAIN AIR CYLINDER
FLOW CONTROL
INJECTION ROD
FLOW CONTROL
23
For Main Cylinder
Injection Rod
Figure 14.0: Flow Control
Publicité
