Publicité
7.6
Loading the Cartridge Kit
NOTE: The unit is set up to mix cartridge kits with an 8
mm) mix rod. To mix cartridge kits with 6
rods, the spindle extension needs to be installed. Refer to
section 8.3 for instructions.
1.
Open the safety cover (Fig. 2.0, 12).
2.
Load the cartridge kit into the cartridge holder (Fig. 2.0, 2).
3.
Pull the mix rod to the fullest extend then align the two through
holes of the rod to the drive spindle (Fig. 2.0, 6).
4.
Turn the cartridge kit lightly in the clockwise direction to lock it
to the spindle.
5.
Insert the plunger assembly (Fig. 2.0,16) into the cartridge
holder with the plunger correctly seated inside the cartridge.
6.
Align the dowel pins of the plunger assembly with the bayonet
slots in the cartridge holder and turn counterclockwise until it
locked in.
7.
Connect the air hose into the plunger air inlet (Fig. 2.0, 4).
8.
Close the safety cover.
19
(203
''
(152 mm) mix
''
Publicité
