Publicité
4.
Set the air pressure to 80 psi (5.5 bar) minimum.
•
•
5. The desired air pressure will be displayed on the screen.
6. Turn on the unit by pressing the power button (Fig. 4). The
cartridge holder should move up to the Home position. If it
does not move up, please check the pressure connection.
7.5 Cartridge Kit Preparation
7.5.1 Injection Kit
The TS6500 Mixer has an automatic injection device that will
inject the hardener into the catalyst before the mixing cycle starts.
However, the valve in the mix rod needs to be opened before
placing the kit in the machine. Follow the below instructions to
open the valve.
1.
Insert the ram rod into the mix rod.
2.
Push the ram rod to force the valve open.
3.
Follow the instructions in section 8.7 to mix the
injection kit.
17
Rotate the air pressure regulator knob (Fig. 2, 9)
clockwise to increase the air pressure.
Rotate the air pressure regulator knob
counterclockwise to decrease the air pressure.
Publicité
