Parkside PAKS 20-Li E5 Mode D'emploi page 59

˜ Working with wood that is
under tension
NOTICE! Risk of product
m
damage!
Horizontal lumber should not be
u
in contact with the ground on the
underside of the cut, otherwise the
saw chain could be damaged.
[ 9 ]
It is important to carry out the
working steps in the correct order
when working with wood that is
under tension. Otherwise the saw
chain could jam or there could be
[ 9 ]
a kickback.
Wood under pressure should always
be orked rst on the push side.
Only then can a separating cut be
made on the 'pull' side. This helps
to prevent the sa chain
jamming.
Trunk is bent downwards
Start by making a relief cut 1
(appro . of the trunk diameter) on
1
3
the push side ( ig. 1).
Then make a separating cut 2
(approx. of the trunk diameter) on
2
3
the pull side ( ig. 1).
Trunk is bent upwards
Start by making a relief cut 1
(appro . of the trunk diameter) on
1
3
the push side ( ig. 2).
Then make a separating cut 2
(approx. of the trunk diameter) on
2
3
the pull side ( ig. 2).
˜ Kickback
(Fig. H)
If the saw chain
upper edge of the guide bar
product can kick back.
from
9 ] [
jams on the
9 ] [
, the
8 ] [
˜ Drawing in
(Fig. I)
If the saw chain
edge of the guide bar
jerk violently away from the operator.
˜ Working safely
Keep the product in good working
order to prevent injury.
If the product has been dropped,
check for signi cant damage or
defects.
Do not use the product while
standing on a ladder or with
unsteady footing.
Do not be tempted into making a
poorly considered cut.
You could endanger yourself and
others.
Change your working position
regularly. Using the product for a
long time can lead to vibration-
related circulation disorders of the
hands. You can extend the usage
duration by using appropriate gloves
or by taking regular breaks. Note
that any personal predisposition to
poor blood circulation, low external
temperatures or large prehensile
forces can reduce the usage period.
˜ Cleaning and maintenance
WARNING! Risk of injury!
m
l ays s itch the product o and
u
remove the battery before carrying
out any work on the product.
NOTE
Replacement parts not listed (e.g.
u
switches) can be ordered via our
service hotline.
Clean the product thoroughly after
u
every use.
jams on the lower
9 ] [
, the rail can
8 ] [
GB/IE 57