Scheppach BC-MP220-X Notice D'utilisation page 24

Switching off
1. Release the on/off switch (2).
2. Move the product into the parking position.
3. Pull out the safety key (4).
4. Remove the battery.
CAUTION
After switching off, the product will run on. Wait until the
product has come to a complete stop.
WARNING
Danger of injury!
To switch off the product, switch off the motor, wait for it
to stop, remove the battery and pull out the safety key.
10.3 After mowing
• Check all screws and nuts before the next use. Tight-
en up loose screws.
• Please also observe the chapter "Storage".
11 Working instructions
Note:
When mulching, the cuttings are shredded in the closed
lawnmower housing and then dispersed on the lawn.
Grass collection and disposal are not required. The fine
green waste falls back into the grass root as a natural fer-
tiliser, adds moisture to the lawn and supplies it with im-
portant nutrients.
As a general rule, the lawn must be mowed relatively of-
ten so that only small amounts of mulch remain on the
lawn. It is therefore best to mulch the lawn at least once a
week and set the mower so that only approx. 40% of the
total height of the lawn is mulched.
• Only cut with sharp, flawless mowing blades so that
the blades of grass do not fray and the lawn does not
turn yellow.
• Only guide the product at walking pace.
• To achieve a clean cut, guide the lawnmower in the
straightest possible paths. These strips should always
overlap by a few centimetres so that no patches re-
main.
• Keep the underside of the mower housing clean and
be sure to remove grass debris. Deposits make the
starting process more difficult, impair cutting quality
and grass discharge.
• On slopes, the cutting path should be made perpen-
dicular to the slope. It is possible to prevent the lawn-
mower from slipping by lifting it upwards at an angle.
24 | GB
11.1 After mowing
CAUTION
After switching off, the product will run on. Wait until the
product has come to a complete stop.
• Always allow the engine to cool down before parking
the lawnmower in an enclosed space.
Remove grass, leaves, grease, and oil before storage.
Do not store other objects on the lawnmower.
• Please also observe the chapter "Storage".
12 Cleaning and maintenance
WARNING
Have maintenance and repair tasks that are
not described in this operating manual, car-
ried out by a specialist workshop. Use only
original spare parts.
There is a risk of accident! Always carry out
maintenance and cleaning work with the mo-
tor switched off and the mains plug discon-
nected. There is a danger of injury! Let the
Product cool down before all maintenance
and cleaning tasks. Elements of the engine
are hot. There is a danger of injury and burn-
ing!
The product can start unexpectedly and cause injuries.
– Switch off the product before all cleaning and main-
tenance work.
– Allow the product to cool down.
– Remove the battery!
CAUTION
Wear protective gloves when handling the
blades!
• Pull the safety key out.
12.1 Cleaning (Fig. 7)
• Clean the underside of the lawnmower with the clean-
ing spatula (6). The cleaning spatula (6) helps to re-
move coarse and larger plant debris from the blade
area. Cleaning the underbody is easier and more thor-
ough immediately after use. Dirt and plant residues
are still fresh then and can be loosened more easily.
Turn the product onto the side.
• Keep protective devices, air vents and the motor
housing as free of dust and dirt as possible. Rub the
product clean with a clean cloth* or blow it off with
compressed air* at low pressure. We recommend that
you clean the product directly after every use.
• Ventilation openings must always be free.
• Always keep the product clean, dry and free from oil
or grease. Remove dust after each use and before
storage.
• Do not use any cleaning products or solvents; they
could attack the plastic parts of the product. Make
sure that no water can penetrate the product interior.
www.scheppach.com