Publicité
Les langues disponibles
Les langues disponibles
IST-1424.CE02.02
Description of the items relating to the outputs:
This description is the same as one written in the chapter CONFIGURE SENSORS. Please see
page 16 (OUTPUT N, SILENCEABLE, SILENCE T., DELAY ON, DELAY OFF/TIME ON, POS.LOGIC, LATCHED).
At the end of the screen is written CONTINUE to proceed in the configuration (in the configurations of
outputs relative to threshold 1 and threshold 2). Press again
screen of the outputs on the threshold 3, and Fault, there is the message
SAVE, that allows you to save the configuration entered.
Pressing
the confirmation window will appear. Press again
ENTER
confirm, or press
to go back and make changes.
ESC
If this procedure is correct, a window notifies you that the operation has
been successful. -----------------------------------------------------------------------
Then the screen returns to the Zone configuration.
DELETE (Level 2)
: This item allows you to delete a Zone or a group of Zones.
WARNING: deleting a zone, relay outputs, configured no longer be available.
To delete a zone, simply press key
Then using
and
delete. ------------------------------------------------------------------------------------
The first line acts on a single Zone. Pressing
highlighted the number of the single zone. Then with numerical keys or
with
and
you choose the number of Zone you want, then
pressing again
will appear the confirmation window.
ENTER
Pressing
on the second line, will be highlighted the 1
ENTER
of the group. -----------------------------------------------------------------------------
You can delete all zones, between 2. Both from the smallest
number too largest, or the contrary. If two numbers, of zones were
equal, the effect is equal to management of a single Zone.
With numeric keys or with
you want. With
and
Then pressing
the confirmation window will appear. ------------------
ENTER
Press
to confirm, or press
ENTER
you will return to the previous step.
After confirmation, the window will notify that the operation has been
successful. -------------------------------------------------------------------------------
Then the screen returns the beginning of the management the deletion.
MODIFY (Level 2)
: This item allows modifying a Zone already configured. Press
5
simply press key
. The parameters are modified and saved in a similar way to the configuration of
the Zone.
DETAILS
: This item allows you to see parameters of a Zone already configured, pressing
item or simply press key
the zones and the number of the corresponding output. In case you want to go back, press
You can scroll through them using
status, and the enabling status of the Zone.
TECNOCONTROL S.r.l. - Via Miglioli, 47 20090 SEGRATE (MI) - Tel. 02. 26 92 28 90 - Fax 02. 21 33 734
CE424P / User Manual
4
or
ENTER
key, you can choose which Zone or group to
ENTER
and
you choose the number of zone
you can go from one extreme to another.
to go back. Each time you press it,
ESC
6
. The voices are the same as the configuration of the Zones, are shown
and
. Then at the end of the screen, is also referred to its
, you can continue until, in the configuration
ENTER
to
ENTER
on the relevant item.
on the first line, will be
st
zone number
Pag. 31/50
ZONE CONFIG.
ZONE
N.
1
CONFIGURED
DELETE
ZONE
N.
FROM N.
TO N.
DELETE
ZONE
N.
FROM N.
TO N.
DELETE
CONFIRM ?
YES = ENTER
NO = ESC
DELETE
ZONE
N. 1
DELETED
on its item or
ENTER
on its
ENTER
.
ESC
Publicité
