Installation Warnings; Positioning - Barazza 1ABFY Manuel D'installation Et D'emploi

2.2

Installation warnings

Installation must be carried out only by authorised and specialised personnel in respect of the warnings,
instructions and provisions contained in this document.
Before installing the device, make sure the pre-existing electrical systems comply with current legislation
and are compatible with the ID plate of the device being installed in terms of voltage [V], frequency [Hz]
and power [W].
The device is supplied with a power cord with 16A Schuko plug.
Make sure the power cord is not crumpled, crushed or bent.
Do not wind up the power cord and make sure it does not create an obstacle or hazard to people.
The power cord must not come into contact with liquids, sharp or hot objects and must not be exposed to
corrosive substances.
Do not touch the device with damp or wet hands/feet or without protection (e.g. suitable gloves and
shoes).
Do not insert screwdrivers, kitchen tools or other objects between the protective devices or in moving
parts.
Do not allow children or animals to come into contact with the power cord.
Do not position power strips or portable power packs on the rear of the device.
Do not use extension cords with the power cord to prevent overheating.
Caution! The plug must be accessible when installation is complete! If this is not possible, the device's
power system must be equipped with a suitable omnipolar disconnection device.
2.3

Positioning

It is recommended not to install the device in locations with a poor air exchange or high temperatures such
as places exposed to direct sunlight or atmospheric agents. Do not install the device near sources of heat.
Caution! When installation is complete, make sure there is nothing obstructing the opening of the door.
Note: in order for the device to function properly, it is mandatory to guarantee a vent stack with minimum
2
section 250 cm (fig. 5) behind the device itself.
Caution! Once positioned in the recess, secure the device using suitable screws.
Fig.5 - Dimensions of recess and product
6