Attaching An Alternative Anti-Tip Device; Attaching An Edge Protection - Bosch B18IF800SP Instructions D'installation

2. Attaching an alternative anti-tip
device
Important note:
If the anti-tip brackets cannot be attached securely, an
alternative anti-tip-device can be attached. However,
ensure that there is no play between the appliance and
the anti-tip-device. If possible, always screw the wooden
beam to existing studs on the rear panel of the
installation niche.
1. Specify the attachment points of the anti-tip-
brackets according to the chapter on "Dimensions
of the installation niche".
Note:
If the installation niche is deeper than the
appliance, select a beam which has a larger
cross section or attach 2 beams.
The beam must cover the appliance by
at least 2" (50.8 mm).
2. Mark the installation height (lower edge of the
beam) on the rear panel of the installation niche.
3. Select screws according to the thickness of the
wooden beam: length = min. 2.5 x beam
thickness, diameter #12 or #14.
Note:
Choose the number of screws according to the
installation niche width, thereby ensuring that the
beam can be attached securely.
4. Depending to the subsurface:
Locate wall studs in the rear of the installation
niche and accordingly transfer their location to the
wooden beam
or fasten suitable dowel into the rear wall.
5. Predrill the wooden beam.
6. Attach the wooden beam to the rear panel of the
installation niche.
3.

Attaching an edge protection

To protect the edges of the installation niche, it is
recommended to attach edge protection made of a
suitable material.
The following are special installation
steps. Instructions are provided after
chapter C.
Change over door hinge, see
"Changing over the door hinges".
Sealing mat, see "Removing/
changing over the sealing mat"
Side-by-Side installation,
see "Side-by- Side installation".
Connecting the water, see
"Preparing to connect the water".
en-us
13