Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
13
̈
Drill a
/
" (10 mm) diameter hole any depth
32
exceeding the minimum embedment. Use the provided
drill.
̈
Clean hole or continue drilling additional depth.
̈
Manually insert the screw into the wall plug until the
screw begins to resist.
̈
Knock the wall plug and screw into the hole until the
1
screw head is approx.
bracket.
̈
Tighten the screw.
̈
Additionally use the supplied wood screws
(if the subsurface allows).
/
" (13 mm) from the anti-tip
2
7.
Attaching an alternative anti-tip
device
IMPORTANT NOTE
If the anti-tip brackets cannot be attached securely,
an alternative anti-tip device can be attached.
However, ensure that there is no play between the
appliance and the anti-tip device.
If possible, always screw the wooden beam to existing
studs on the rear panel of the cavity.
̈
Saw the wooden beam (cross section min. 3" x 4")
to the required length.
Length is equal to the width of the installation cavity!
– If the installation cavity is deeper than the
appliance, select a beam which has a larger cross
section or attach 2 beams.
– The beam must cover the appliance by
at least 2" (50.8 mm).
̈
Mark the installation height (lower edge of the beam) on
the rear panel of the cavity.
NOTE
19
Publicité
Table des Matières
