Maintenance & Care - Elem Garden Technic CBT2538 Traduction Des Instructions D'origine

MAINTENANCE & CARE
AIR FILTER
Accumulated dust in the air filter will
reduce engine efficiency. Increase fuel
consumption and allow abrasive particles
to pass into the engine. Remove the air
filter as often as necessary to maintain in
a clean condition.
Light surface dust can readily be removed
by tapping the filter. Heavy deposits
should be washed out in suitable solvent.
Remove filter cover by loosening air
filter cover knob.
ADJUSTING CARBURETOR NOTE
Do not adjust carburetor unless necessary.
If you have trouble with the Carburetor,
see your dealer. Improper adjustment
may cause engine damage And void
warranty.
FUEL FILTER
Fuel tank is fitted with a filter.
Filter is situated at the free end of fuel
pipe and can be picked out through fuel
port with a piece of hooked wire or The
like.
Check the fuel filter periodically. Do not
allow dust to enter into fuel tank. Clogged
filter will cause difficulty in starting
engine or abnormalities in starting engine
or abnormalities in engine performance.
When filter is dirty, replace the filter.
When the inside of the fuel tank is dirty,
it can be cleaned by rinsing the tank out
with gasoline.
CHECK SPARK PLUG
Do not attempt to remove the plug from a
hot engine in order to avoid possible
damage to the threads.
37
TROUBLE SHOOTING
Clean or replace the plug if fouled with heavy oily deposits.
Replace the plug if the center electrode is worn rounded at the end.
Spark gap 0.6-0.7mm (.023".028")
Fastening torque = 145-155kg.cm (125-135in.lb)
TRANSPORT, HANDLING
- The engine should be turned off when the unit is moved between work areas.
- After the engine has stopped, the muffler is still hot. Never touch hot parts such as the muffler.
Confirm that the fuel is not leaked from tank.
-
EXTENDED STORAGE
Inspect, clean and repair unit if necessary.
Remove all fuel from tank.
Start engine-This will consume all fuel in fuel line and carburetor.
Remove spark plug and pour one tea spoon of clean motor oil into spark plug hole of cylinder-replace spark
plug.
Store in clean, dry, dust free area.
FAILURES such as difficulty in starting engine, irregularity in functions and abnormality in performance can normally
be prevented if careful attention is paid to all operating instructions and maintenance procedures.
Should the engine not function properly, check the following;
That the fuel system is in good condition and fuel is flowing to the engine.
The ignition system is in good condition and the spark plug, sparks correctly;
Compression of the engine is adequate.
FAILURE TO START
Dispose of fuel in tank.
Insure that fuel is fresh and clean.
Check fuel filter to make sure it is clean. (Replace filter if necessary).
Make sure air filter elements are clean.
Install new, properly gapped spark plug.
When there is serious trouble with the unit, do not try to repair it yourself but have your distributor or dealer do it
for you.
38