Elem Garden Technic CBT2538 Traduction Des Instructions D'origine page 17

CUTTING WITH A NYLON HEAD
TRIMMING:
This is feeding the trimmer carefully into the material you wish to cut. Tilt the
head slowly to direct debris away from you. If cutting up to a barrier such as
fence, wall or tree, approach from an angle where any debris ricocheting off the
barrier will fly away from you, Move the line head slowly until the grass is cut
right up the barrier, but do not jam (overfeed) the line into the barrier. If trimming
up to a wire mesh or chain linked fence be careful to feed only up to wire. If you
go to far the line will snap off around the wire. Trimming can be done to cut
through weed stems one at a time. Place the trimmer line head near the bottom
of the weed-never high up which could cause the weed to chatter and catch the
line. Rather than cut the weed right through, just use the very end of the line to
wear through the stem slowly.
WARNING
Do not to use a steel blade for edging or scalping.
SCALPING AND ENGING:
Both of these are done with the line head tilted at a steep angle Scalping is removing
top growth leaving the earth bear.
Edging is trimming the grass back where it has spread
over a sidewalk or drive way. During both edging and
scalping, hold the unit a steep angle and in a position
where the debris, and any dislodging dirt and stones,
will not come back towards you even if it ricochets off
the hard surface. Although the picture shows how to
edge and scalp every operator must find for himself the
angles which suits his body size and cutting situation.
WARNING DANGER
Do not trim in any area where there are strands of fencing wire. Wear protective safety
protecting , Do not cut where you cannot see what the cutting device is cutting.
DANGER
33
FUEL & OIL MIXTURE
Never fill the fuel tank to the very top.
Never add fuel to the tank in a closed non-ventilated area.
Do not add fuel to this unit close to an open fire or sparks.
Be sure to wipe off spilled fuel before attempting to start engine.
Do not attempt to refuel a hot engine.
Fuel used for this model is a mixture of unleaded gasoline and approved engine lubricant. When
mixing gasoline with two-cycle engine oil, use only gasoline which contains NO ETHANOL or
METHANOL(Types of Alcohol) Use Branded 89 octane or higher
Unleaded gasoline known to be of good quality. This will help to avoid possible damage to engine
fuel lines and other engine parts.
MIXTURE RATIO IS 40:1
GASOLINE-40PART
Fuel mixture at the rate other than 25:1 may cause damage to the engine,
Ensure mixture ratio is correct.
FUEL IMPORTANT
The engine uses two-stroke fuel, a mixture Two-stroke fuel may separate. Shake
fuel of gasoline and 2-stroke lubricant 40:1
container thoroughly before each use. Stored fuel ages. Do not mix more fuel than you
expect to use within a month.
GASOLINE
Use branded 89 octane or higher unleaded
gasoline known to be of good quality.
FUEL AND OIL MIXTURE
STORING FUEL
Store fuel only in a clean, safe, approved
Inspect fuel tank making sure that it is container.
Check and follow local clean and fill with fresh fuel. Use a mixture
ordinances. on type and location of 40:1 storage container.
OIL-1 PART
34