Rizzoli ST Série Manuel D'utilisation page 146

7.6 WOOD BOX
To remove the wood box you should extract
it completely, then lift it up a little and pull
it out at the same time. In this way you ac-
WARNING! Do not put inflammable products inside the wood box! The
objects inside the wood box must not reach the upper wall of the wood box.
7.7 PLATE CLEANING AND MAINTENANCE
Radiating plates in special steel need regular
maintenance, in particular they need clean-
ing after every use that brings moisture or
dust on the plate itself. You should clean the
plate when it is tepid, so that the moisture
vanish for evaporation and rust stains do
not occur.
Do not clean the thermal cooker with water
when the thermal cooker is cold. Moreover,
it is important to be sure that the expan-
sion cuts and the hole between the plate
and the frame are not obstructed by dust
or by other residuals: the plate could suffer
deformations, also permanent. When it is
necessary, you should clean also the beating
of the circled removing eventual residuals.
The plates are all worked in with non acid
anti-corrosion oil. The use of the thermal
cooker deletes this oil layer and so the con-
tact with water may cause small rusty stains.
7.8 MAINTENANCE OF THE LIGHT (ST 90, STK)
WARNING! Before starting any maintenance operation for the light, you must
disconnect it from AC power and be sure that the thermal cooker is not pow-
ered. Be sure that no tension is in the device. Verify also if the thermal cooker
is cold and if the light was turned on in the previous minutes.
Oven lamp suffers high temperatures. Even
if it is designed to work in these conditions,
it could become out of order. You have to
replace it with a lamp with the same fea-
tures (halogen lamp 25W 230V 300° connec-
tion G9). To replace the lamp you have to
unscrew the lamp cover, remove the lamp,
cess to the lower part of the thermal cooker.
To reinsert the wood box you can make the
same process reversed.
In this case you have to wipe the plate with
a rag soaked with non acid oil. If the rusty
stain is not being cleaned, you could have to
wipe the plate with a lightly abrasive paper
or with the abrasive sponge given together
with the thermal cooker. To restore the pro-
tecting layer wipe the plate with little oil.
Radiating steel plates, exposed to contin-
uous heating, trend slowly to take a bur-
nished colour; if you want to accelerate the
process, repeat frequently the oil wiping.
Together with the thermal cooker are giv-
en two exclusive products, studied for the
cleaning and the maintenance of the plate:
on how to use them please read the instruc-
tions written on the bottles.
To remove the plate, you have to lift it up.
When you reinsert the plate, keep in mind
to leave the 1 or 2 millimetres to allow the
thermal expansion of the plate itself.
insert the new lamp and finally screw in the
lamp cover. Seldom, it is necessary to clean
the glass of the lamp cover. To make this,
you have to unscrew the lamp cover, remove
the external residuals due to the cooking
steams, wash the lamp cover and once it is
dry you can screw it in its place.
144