lopital Reflex Mode D'emploi page 28

Masquer les pouces Voir aussi pour Reflex:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Charging the Reflex
• The Reflex is an electrically driven
high/low shower-toilet seat that oper-
ates on battery power. These batteries
must be charged on a daily basis. The
charging point is located on the back
of the seat and is covered by a flap.
• If the batteries are almost empty the
LED flashes red: batteries need to be
recharged soon. When the batteries
have been drained of most of their
power, the LED on the control panel
will be lit up red continuously, which
indicates that they must be charged
immediately (Chair can no longer be used).
• Open the cover and connect the charger to the Reflex (Stand-by mode).
• When connecting the charger to the chair all functions are non operating.
• If the signal light on the charger is green, the batteries are charged sufficiently.
The charger can remain attached once the batteries have been sufficiently charged.
• Disconnect the charger from the Reflex and close the flap. Only use the original charger
supplied with the chair.
• The reflex is ready for use after resetting (see led burning green).
LED not burning:
LED is burning green:
LED flashes red:
LED lights up red continuously: Batteries are empty and need recharging immediatly.
We recommend that you install the charger at a permanent location in a dry
room (therefore not the bathroom or shower room).
Connect the charger to the chair after use to conserve batteries.
28 | Instructions for use | Mobile shower seat 'Reflex'
Charger connection point
Chair is in non-operating mode and cannot be used.
Chair can be operated (after pressing down the raise buttons
for 1 second).
Batteries need to be recharged soon (chair is still usable).

Publicité

Table des Matières
loading

Table des Matières