Water Ace RTS5-01 1/2 HP Manuel D'utilisation page 9

Process C, continued.
Cement as many sections and couplings of rigid 3/4"
STEP
PVC pipe needed to connect the 3/4" PVC adapter in the
17
discharge tee to the 3/4" male adapter on the tank tee
inlet. Set pressure in the diaphragm pressure tank to
2 pounds less than the cut-in pressure of the pump. The cut-in
pressure of these Water Ace pumps is factory preset to 30 PSI. If this
cut-in setting has not been changed, then the diaphragm pressure
tank should be set to 28 PSI. Total installation should look like the
drawing at right.
Open a faucet or two in
STEP
the house. Start motor.
18
Turn regulator adjustment
screw down tight. If pump
is properly primed, a high pressure
will immediately show on the
pressure gauge. With pump operating
at high pressure, slowly unscrew
regulator stem until maximum water
flow is obtained without dropping
to zero. If pressure falls completely,
retighten stem and readjust. Steady pressure must not be less
than 24 lbs. for the RC5 and 32 lbs. for the RC10. If no pressure
shows, stop motor, remove pressure regulator from pump, add
more water, and try again.
WARNING: Risk of explosion. If you change pressure
switch settings, set the cut-off pressure low enough to
shut off the pump. If a valve shuts off and the cut-off
setting is too high, the pump will run continuously
without water flow, causing overheating and possible
explosion which can cause serious burns and damage.
Notice: Plastic shipping base is attached to prevent movement in shipment only.
Do not return pump if shipping base becomes cracked in shipment, as pump
REGULATOR
STEM
performance will not be affected.
** Requires R-E520-100 ejector (sold separately).
If you install your pump with a 2" single-pipe
("Packer") jet, please follow the installation
instructions included with the Packer jet kit.
9