Ascend X3 Premium Mode D'emploi page 24

SCREEN DISPLAY
No. Display
1
2
3
Description of functions
The "TIME" display has two modes: Forward Counting and
Countdown.
Forward Counting:
Counts up from the start of your session (0:00) up to a maximum of
99:59 minutes. Upon reaching the maximum value, the value starts
back at zero but the treadmill does not stop.
Countdown:
Allows the user to set a timed workout objective. To use this feature,
select the Time window by pressing the "MODE" button in standby
mode. Set the time objective by pressing the "+" button to increase
the time and the "-" button to decrease the time.
The objective range can be selected in increments of 1 minute,
from 5 minutes (5:00) to 99 minutes (99:00). To start the
workout, press the START button. The treadmill will then count
down to 0:00 from the set time objective.
Upon reaching 0:00, the machine will decelerate and stop,
displaying "End". The display will then return to standby mode after
5 seconds.
SPEED window: Displays the current speed data in operation
state. The speed display range is 0.8-18.0 km/h. It can be
adjusted throughout manual programs by using the "+" and "-"
buttons.
DISTANCE window: The "DISTANCE" display has two modes:
Forward Counting and Countdown.
Forward Counting:
Increases from 0.0 to 99.9 km and resets to 0.0 after reaching
the maximum. The treadmill will not stop. DISCLAIMER: The
distance feature is an estimate based on the average stride
length of a 160 lb biological male. Results shown may vary from
reality.
Countdown:
Allows the user to set a distance workout objective. To use this
feature, select the distance window by pressing the "MODE"
button in standby mode. Set the distance objective by pressing
the "+" button to increase the distance and the "-" button to
decrease the distance.
The objective range can be selected in increments of 0.1 km,
from 1 km (1.00) to 99 km (99.0). To start the workout, press
the START button. The treadmill will then count down to 0.0
from the set distance objective.
Upon reaching 0.0, the machine will decelerate and stop,
displaying "End". The display will then return to standby mode
after 5 seconds.
HRC AND FAT
ASCEND X3 PREMIUM FOLDABLE TREADMILL
23