Num'axes CANICALM EXCEL Guide D'utilisation page 17

CAUTION: the adjustment button has a stop for the minimum sensitivity (0) and for the maximum
sensitivity (10).
Level 0 = minimum barking detection sensitivity (only strong barks will be detected and activate
the product)
Level 10 = maximum barking detection sensitivity (light barks will activate the product)
Checking and replacing battery

The battery condition is checked in 3 distinct occasions:
- when switching On the collar:
5 beep sounds + indicator light flashes in red 5 times (instead of 1 beep sound + 1 flash) = weak battery
- when the collar is On:
indicator light flashes in red 5 times every 5 seconds (instead of 1 time every 5 seconds) = weak battery
- when switching Off the collar:
5 beep sounds + indicator light flashes in red 5 times (instead of 3 beep sounds + permanent red)
then the collar goes out = weak battery
Prepare to replace the battery.
When the battery is too weak, the product switches to safety mode and the system locks up.
NUM'AXES advises to use the same type and same brand of batteries as those supplied in your
new purchased product. Other brands of batteries may not operate, or may not be completely
compatible with your product.
You can purchase the suitable batteries from NUM'AXES or from you distributor.
Replace the battery as follows:
- Unscrew the battery cover using a coin.
- Remove the old battery.
- Insert the new battery (Lithium 3-V CR2) paying attention to follow polarity indicated on the collar
(ref. Diagram 2).
- Retighten the battery cover using a coin. A beep sound is emitted indicating the correct installation
of the battery. If you do not hear any beep sound when retightening the battery cover, remove the
battery immediately from its housing. Check the polarity before trying again.
NOTE : when changing the battery, there can remain some power in your collar. In that case, the
collar does not emit any beep sound when you retighten the battery cover after inserting the battery.
To make sure it operates correctly and that the battery is correctly installed, turn your collar on with
the magnetic key.
After changing the battery, next time you will switch on the collar, it will be in the last selected
operating mode.
Gb - 17