Tait TM8100 Guide De L'utilisateur page 39

3. Cut the negative and the positive wires where the in-line
All manuals and user guides at all-guides.com
4. Insert each end of the negative wire into one of the in-
5. Connect the negative wire to the battery ground.
6. Repeat step 4 for the positive wire and connect it to the
Installing the radio in the U-bracket
1. Connect the antenna and power cables to the rear of
2. Position the radio in the U-bracket so that the holes in the
3. Screw the radio into position using the four thumb screws
4. Position the radio in the U-bracket for best viewing angle,
30 Radio installation
fuse holders will be placed (as close to the battery
as possible).
Note: Do not install the fuses until the installation
is ready to be checked.
line fuse holders and crimp them to force the metal
contacts onto the wires.
positive terminal of the battery.
the radio.
U-bracket line up with the holes in the radio chassis.
but without fully tightening the screws.
then tighten the thumb screws.