Tait TM8100 Guide De L'utilisateur page 36

Installing the microphone
All manuals and user guides at all-guides.com
1. Plug the microphone into the microphone socket on the
2. Slide the microphone grommet along the microphone
3. Squeeze the grommet and push the remaining corners
4. Check that the grommet is seated correctly in the cavity.
Installing the antenna
Install the external antenna according to the supplier's
instructions. Good quality 50 ohm coaxial cable must be
used, such as RG58 or UR76.
of the vehicle.
Warning: RF exposure hazard
To comply with FCC RF exposure limits, this product must be
installed using an externally mounted antenna with either a
2.15dBi or 5.15dBi gain.
This antenna must not be mounted at a location such that
any person or persons can come closer than 0.9m
(35 inches) to the antenna.
28 Radio installation
Important: The microphone grommet must be installed
whenever the microphone is plugged into the micro-
phone socket. When installed, the grommet has two functions:
I to prevent damage to the microphone socket when
there is movement of the microphone cord, and
I to ensure that the control head is sealed against
water, dust and other environmental hazards.
control head.
cord and push two adjacent corners of the grommet into
the microphone socket cavity.
into position.
Important: The cable should be routed in a manner that
minimizes coupling into the electronic control systems
microphone
grommet
control head