Tait TM8100 Guide De L'utilisateur page 30

I The space containing the radio equipment shall be iso-
All manuals and user guides at all-guides.com
lated by a seal from the space containing the LP gas con-
tainer and its fitting.
I Outside filling connections shall be used for the LP gas
container and its fittings.
I The LP gas container space shall be vented to the outside
of the vehicle.
Important: Non-standard radio installations
The installation U-bracket described in this guide has been
designed so that there is enough airflow around the radio to
provide cooling.
If a non-standard installation method is used, care must be
taken that sufficient heat can be dissipated from the radio
heatsink fins and the bottom surface of the radio chassis.
For this to be achieved, there must be a gap of more than
10mm (0.4 inch) between the bottom surface of the radio
chassis and the mounting surface. This is illustrated in the
following diagram.
Important: Negative ground supply
TM8100 radios are designed to operate only in a negative
ground system.
10mm
mounting surface
Installation warnings 23