Tait TM8100 Guide De L'utilisateur page 35

numbers in the diagram on the previous page refer to the
All manuals and user guides at all-guides.com
numbered steps below.
1. Plug the control head loom onto the control
head connector.
2. Insert the bottom edge of the control head onto the two
clips in the front of the radio chassis, then snap
into place.
Removing the control head
Important: During this procedure, take care that the
chassis seal is not damaged. Damage to this seal
reduces environmental protection.
1. On the underside of the radio, insert a flat-bladed screw-
driver between the control head and the radio chassis
seal, in either position
pattern (•
2. Use the screwdriver to lift the control head off the chassis
clip, then repeat in the other position.
The control head can now be removed from the
radio body.
1
Note: Insertion points
on the radio chassis by a dot-dash-dot
–
•).
2
or .
2
1
and
2
1
Radio installation 27
are indicated