Tait TM8100 Guide De L'utilisateur page 37

Antenna termination
All manuals and user guides at all-guides.com
1. Run the free end of the coaxial cable to the radio's
2. Terminate the free end of the cable with the BNC
Power cable
to 8A of current. The radio will tolerate a supply voltage
range of 10.8V to 16.0V at the radio.
In vehicles with a supply voltage greater than 16.0V, such as
many trucks, it is essential to provide a suitably rated DC to DC
converter. This will isolate the radio from excessive battery volt-
age and provide the correct DC operating conditions.
Installing the power cable
as vehicle alarms, engine management systems and in-car
entertainment systems. Check that the vehicle owner has the
necessary information to make all electronic equipment func-
tion correctly after battery reconnection.
1. Disconnect the vehicle's battery, unless specifically
2. Determine where the power cable will be routed.
mounting position and cut it to length, allowing 20 -
30cm (8 - 12 inches) excess.
plug supplied.
Important: This radio is designed to operate from a
nominal 12V negative ground supply and may draw up
Important: Disconnecting the vehicle's battery may
cause problems with some electronic equipment, such
prohibited from doing so by the customer, vehicle manu-
facturer, agent or supplier.
If the battery is not disconnected, exercise extreme
caution throughout the installation and install the fuses
only when the installation is ready to be checked (see
"Installation checks" on page 32).
Important: The power cable should be protected
from engine heat, sharp edges and from being
pinched or crushed.
Radio installation 29