Dogtra ARC800 FREE PLUS Guide D'utilisation page 42

NOTE 3: When a charger is not in use, disconnect it from
the power source. Fully charge the batteries if the unit
is to be stored without use for a period of 3 months or
more.
Follow the steps below to charge your system:
1. Open the rubber plugs on the battery charging
receptacles and plug in the charging cable.
2. Plug the charger into a 220-volt wall outlet or, if using
the auto charger, plug into a cigarette lighter only for
lithium polymer batteries. All indicator lights should
glow red when properly plugged in and the unit will
automatically shut off during the charging process. You
will need to turn the unit on again before use once the
unit is fully charged and unplugged from the battery
cable.
3. The lithium polymer battery is fully charged within
2 hours. The lights will stay red during the charging
process and turn green once the unit is fully charged.
4. After charging, cover the battery charging receptacles
with the rubber plugs.
80
Charger Info
Manufacturer: E-SUN
Manufacturing country: CHINA
Model name: MKC-1001500SEU
INPUT: 100-240V~50/60Hz 0.4A
OUTPUT: 10V 1500mA 15.0W
Attention!
During battery charging, the unit must be close to
the wall outlet and the wall outlet must be easily
accessible for security reasons.
81