Air Regulation - Rizzoli RNE Manuel D'utilisation

The regulation of starting air allows the direct en-
trance of air from the room in which the cooker is
installed to the combustion chamber. The valve is
closed in the right position, it is open in the left
position. In case of model with flue outlet on the
left, the regulation of the lever is symmetrical
(valve closed in the left position, open in the right
position).
When starting, it is suggested to open both the
devices that later shall be closed when the fire will
be started for the normal working of the cooker.
The cooker is designed to be used with the start-
ing regulations closed, using they in different ways
does not allow to the cooker to work at its maxi-
mum and may cause damages. To light the fire, you
can use as combustible well dried wood, broken
thin, together with the products available in com-
merce. The combustion might be difficult as far as
the chimney is cold. The necessary time depends
on the chimney and the weather conditions.
WARNING! It is important that the wood starts to burn quickly. The lighting of a big
amount of wood in starting phase can cause an excessive production of smoke and a
quick gas emission with consequent damage to the cooker.
3.3

AIR REGULATION

On each model there are two air regulations: air
entrance lever, primary and primary air regulation
lever.
The entrance of comburent air inside the cooker is
regulated by a valve ruled by a lever placed below
the oven. The valve is closed in the right position
while is open in the left position.
To regulate this device, see picture 23. In case of
model with flue outlet on the left, the regulation
of the lever is symmetrical (valve closed in the left
position, open in the right position).
The primary air regulator, located in the front of
the cooker, is ruled by a graduate hand grip which
regulates the combustion speed. Low values en-
sure less power and bigger autonomy. High values
ensure more power and less autonomy. The regu-
lator is automatic and maintains steady the heating
produced by the cooker.
The secondary air is set automatically according
Picture 22 - Regulation of starting air.
both to the setting of opening of the air entrance
lever and to the primary air lever and the effective
working conditions and draught of the device.
The air introduced in correspondence of the fire
door is fixed and set to allow an optimal combus-
tion and, in case of cookers with fire door with
glass, to keep clean the glass.
When the cooker is cold, we suggest to close the
lever below the oven and set the primary air regu-
lator to value 0, in order to limit the undesired air
flow that may cause an anticipated cooling of the
device and the room.
This operation is particularly important when the
external air intake of the cooker is directly con-
nected.
Generally, for an optimal working of the device, it
is suggested to follow the indications for the regu-
lation of air reported in table 5.
82