Publicité
Les langues disponibles
Les langues disponibles
Attaching the Battery Charger Mounting Bracket to the Wall
NOTE: For this procedure, refer to FIGURE 2.2.
1. Place the battery charger mounting bracket on the wall at the desired position.
2. With a pencil, mark the middle hole position.
3. Measure down 6½ inches from the pencil mark and drill one mounting hole.
4. Install the bottom mounting screw until there is a 1/8‐inch gap between the screw head and the wall.
5. Put the battery charger mounting bracket onto the bottom mounting screw.
6. Drill the other two mounting holes.
7. Screw the mounting screws through the battery charger
mounting bracket and into the wall. Tighten securely.
CAUTION
Make sure there is an audible click when mount-
ing battery on the battery charger to confirm
proper mounting. Otherwise, injury or damage
may occur.
8. Put the battery charger in place on the mounting bracket.
9. Plug the battery charger into an electrical outlet.
NOTE: An LED will illuminate when power is applied to battery
charger.
Attaching the Battery Charger to the
Mast Assembly
WARNING
If the battery charger is attached to the mast
assembly and is plugged into a wall outlet, make
sure to unplug the battery charger from the wall
outlet BEFORE using the patient lift. Failure to
unplug the battery charger may result in injury
or damage.
NOTE: For this procedure, refer to FIGURE 2.3.
1. Lock the rear casters to secure the lift in place while
performing this procedure.
2. Remove the two mylar pieces covering the battery charger
mounting holes on the back of the mast assembly.
3. Insert the hook screws into mounting holes.
4. Tighten the hook screws.
5. Mount the battery charger mounting bracket on the hook
screws.
6. Charge the battery. Refer to Charging the Battery on
page 13.
Part No 1150704
All manuals and user guides at all-guides.com
11
Mounting Bracket
Mounting Screws
Bottom Mounting Screw
FIGURE 2.2 Attaching the Battery Charger Mounting
Bracket to the Wall
FIGURE 2.3 Attaching the Battery Charger to the Mast
SECTION 2—ASSEMBLY
Battery and Battery Charger
shown in place
Assembly
Jasmine™ Patient Lift
Publicité
