Invacare Jasmine Patient Lift Manuel D'utilisation Et D'entretien page 26

SECTION 7—MAINTENANCE
Checking and Tightening Mast Pivot
NOTE: For this procedure, refer to FIGURE 7.5.
1. To gain access to the attaching hardware, remove the covers that are on either side of the mast.
2. Check that the locknut is tight and secure on the screw.
3. If needed, do one or more of the following:
• Tighten locknut and back‐off the locknut 1/8 of a turn.
• Replace the locknut.
Jasmine™ Patient Lift
All manuals and user guides at all-guides.com
Boom
Bushing
Teflon Bearing
Nylon Washer
Washer
Screw
Cover
Screws
Mast
FIGURE 7.5 Checking and Tightening Mast Pivot
Teflon Bearing
Nylon Washer
Washer
Cover
Locknut
Mast Connector
NOTE: Lock nuts this side of mast not shown.
26
Part No 1150704