Invacare Jasmine Patient Lift Manuel D'utilisation Et D'entretien page 10

SECTION 2—ASSEMBLY
SECTION 2—ASSEMBLY
Assembling the Patient Lift
Assembling the Mast Assembly to the Base
NOTE: The mast assembly may be removed from the base for
storage or transporting. The mast assembly MUST be properly
secured to the base assembly before use.
NOTE: For this procedure, refer to FIGURE 2.1.
1. Put the base on a level surface so all casters make
contact with the floor.
2. Lock the rear casters. Refer to Detail "A".
3. Unscrew the top knob and remove it from the base.
4. Loosen the bottom knob, but leave it screwed into the
base.
5. Put the tube of the mast assembly into the hole in the
base.
6. While supporting the mast assembly, tighten the
bottom plastic knob.
7. Screw the top plastic knob into the hole in the base.
Jasmine™ Patient Lift
All manuals and user guides at all-guides.com
10
DETAIL "A"
Push tab down to lock
Push tab up to unlock
Base
Caster
FIGURE 2.1 Assembling the Mast Assembly to the Base
Mast
Assembly
Top Plastic Knob
Bottom Plastic Knob
Part No 1150704