Timer
The device can automatically start and stop at a preset time.
Automatically start
1.
Set the device to the desired mode and the desired temperature.
2.
Press the ON/OFF button, the device is now in standby mode.
3.
Press the Timer button.
4.
Use the Up and Down buttons to set the countdown timer the device will automatically
start (1-24 hours).
5.
Press the Timer button. The display shows the selected time until the device starts.
Automatically stop
1.
Set the device to the desired mode and the desired temperature.
2.
Press the Timer button.
3.
Use the Up and Down button(s) to set the countdown timer the device will automatically
stop (1-24 hours).
4.
Press the Timer button. The display shows the timer indication and the selected
temperature.
Deactivate automatic timer
1.
Press the Up and Down buttons simultaneously, continuously until the display shows
'00'.
Pressing the Power button exits the Timer setting.
Drainage of condensed water
The device extracts water from the air. The water is partially evaporated with the discharge of
the warm air. The remaining water accumulates in the water tank. When the tank is full the
device stops automatically and the message Ft will appear on the display.
1.
Make sure the device is switched off and the
plug is removed from the power outlet
(Figure 16, pos. 1).
2.
Remove the cap (Figure 16, pos. 2) from the
water discharge point (Figure 16, pos. 3),
drain the tank in a container or a well.
3.
Don't forget to put the cap back on the water
discharge point.
26
Figure 16