Publicité
Les langues disponibles
Les langues disponibles
Automatic defrost
Frost is detected when the device is operating in the cooling or dehumidify mode and the
built-in temperature sensor detects that the temperature is lower than -1°C. The compressor
will stop temporarily. The device starts to defrost automatically and indicator lights start
blinking. After the temperature has risen sufficiently, the compressor will start working
automatically.
After operation
CAUTION
Do not use the power cable to unplug or carry the device. Do not wind the
power cable too tightly or in sharp corners. Do not wrap the power cable
around the device.
1.
Make sure the device is switched off and the plug is removed from the power outlet
(Figure 16, pos. 1).
2.
Let the device cool down before touching it.
3.
Remove the hot air outlet hose from the window.
4.
Wind the power cable.
Maintenance
WARNING
Do not perform any repairs or modifications to this device.
Maintenance and repairs must be carried out by a EUROM authorized professional. If the
electric cable and/or electric plug are damaged, it should be replaced by the manufacturer or
its service employee or persons with similar qualifications to prevent risks.
Repairs must be carried out in accordance with the appliance manufacturer's
recommendations. Maintenance and repairs requiring the assistance of other qualified
personnel must be carried out under the supervision of a person specialized in the use of
flammable refrigerant media. National gas regulations must be complied with. People who
are working with or intervening in a refrigerant circuit must hold appropriate certification
issued by an accredited body certifying that the person concerned is competent to handle
refrigerant media in accordance with a special assessment recognized by industry
associations. All parts are specially designed for use in air conditioners with R290 refrigerant.
These parts are non-incendiary and should only be replaced with identical repair parts.
27
Publicité
