Publicité
Les langues disponibles
Les langues disponibles
7.
Place the power plug (Figure 12, pos. 1) into
an earthed wall socket that is easily
accessible. Use an earthed wall socket with a
minimum power of 1200 Watt.
Installation to dehumidify
1.
Make sure the device is switched off and the
plug is removed from the power outlet
(Figure 13, pos. 2).
2.
Remove the rubber plug from the drain
(Figure 13, pos. 1) and keep it in a safe place.
3.
Connect the included water drain hose to the
drain of the device (Figure 13, pos. 4).
4.
Place the outlet of the water drain hose in a
bucket (Figure 13, pos. 3).
5.
Regularly check the water level in the bucket.
The end of the hose should not be immersed
in water.
In the dehumidifying mode it is not necessary to
mount the hot air outlet hose.
Remote control
1.
Remove the cover (Figure 14, pos. 1).
2.
Remove the batteries (if present).
3.
Insert two batteries (AAA 1.5 V) (Figure 14,
pos. 2) as indicated in the battery
compartment. Make sure to insert the
batteries correctly.
4.
Replace the cover.
24
Figure 12
Figure 13
Figure 14
Publicité
