Cleaning The Housing And Nozzles; Storage; Technical Data - DS Produkte C-320-70 Mode D'emploi

EN
8. When all parts are dry, replace the cyclone insert in the dust container.
9. Put the lid on the dust container so that the arrow symbol on the dust container
points to the
arrow symbol should now be pointing to the
10. Put the dust container in the device. Make sure that it audibly locks into place.
Cleaning the HEPA exhaust air fi lter
The HEPA exhaust air fi lter is situated behind the protective grill on the back of the
vacuum cleaner.
D

Cleaning the housing and nozzles

• If needed, clean the housing with a damp, soft cloth.
• Regularly remove hair and lint from the nozzles.

Storage

Technical Data

Article numbers:
Model number:
Voltage supply:
Power:
Protection class:
ID Instruction manual:
symbol on the lid. Close the lid by turning it as far as it will go. The
1. Pull down the exhaust hatch latch with fi lter (D) and
remove the hatch simultaneously.
2. Tap it out over a garbage bin. If necessary, clean it with
a soft brush.
Attention: Do not clean the HEPA exhaust air fi lter
with water!
3. Brush or wipe the fi lter compartment if required.
4. Place the exhaust hatch with fi lter in the device and close
the hatch. The hatch must audibly lock into place.
• For storage you hook the fl oor nozzle into the holder on
the back of the device (see fi gure) and close down the
telescopic tube as far as it will go.
• Store the vacuum cleaner in a cool dry indoor room where
it cannot be reached by children or animals.
04765 (pink / silver)
08302 (gold)
08318 (red)
08343 (grey / silver)
09096 (zebra design)
09897 (blue / silver)
C-320-70 / C-320-80
220 – 240 V ~ 50 / 60 Hz
700 W
II
Z 04765_08302_08318_08343_09096_09897 M DS V6 1118
22
symbol.