Avocent DSR 1020 Guide D'installation Et D'utilisation page 96

86 DSR® Switch Installer/User Guide
2. The Details View will appear. Click USB Reset.
3. A warning message will appear, indicating the possible effects of the reset. Confirm or
cancel the reset.
4. To close the Details view, click Details again.
Closing a virtual media session
To close the Virtual Media dialog box:
1. Click Exit.
2. If you have any mapped drives, a message is displayed, indicating that the drives will be
unmapped. Confirm or cancel the operation.
If a user attempts to disconnect a virtual media session or an active KVM session that has an
associated locked virtual media session, a confirmation message is displayed, indicating that
any virtual media mappings will be lost.
Using Smart Cards
You can connect a smart card reader to an available USB port on the client server and access
attached target devices on the DSR switch system. You can then launch a KVM session to
open the Video Viewer and map a smart card.
NOTE: For all smart card readers, you must use a smart card capable DSR x03x model switch and a DSRIQ-VMC
module.
The smart card status is indicated by the smart card icon at the far right of the Video Viewer
toolbar. The following table describes the smart card status icons.
Table 5.4: Smart Card Icons
Icon Description
A smart card is not in the smart card reader, or a smart card reader is not attached.
A smart card is in the smart card reader but has not been mapped yet.
A smart card is mapped (green).
To map a smart card:
1. Open a KVM session to display the Video Viewer window menu.
2. Insert a smart card into the smart card reader attached to your client server.
All manuals and user guides at all-guides.com