Avocent DSR 1020 Guide D'installation Et D'utilisation page 39

Selecting target devices for Scan mode
In Scan mode, the DSR switch automatically scans from port to port (target device to target
device). You can scan multiple target devices, specifying which devices to scan and the number
of seconds that each will display. The scanning order is determined by placement of the target
device in the list. The list is always shown in scanning order. You can, however, choose to
display the target device's name or EID number by pressing the appropriate button.
NOTE: Scanning is available only to local users.
To add target devices to the Scan list:
1. If the OSCAR interface is not open, press
2. Click Setup - Scan to open the Scan dialog box shown in Figure 3.8.
Figure 3.8: OSCAR Interface Scan Dialog Box
3. Determine the order within the list to add the target device. If there are no target devices in
the Scan list, your cursor will appear in a blank line at the top of the list.
-or-
To add a target device to the end of the list, place your cursor in the last target device
entry and press the
-or-
To add a target device within an existing list, place your cursor in the line below
where you want to insert a new target device and press
4. Type the first few characters of a target device name or port number to scan. The first
matching target device will appear in the line.
-or-
All manuals and user guides at all-guides.com
key.
Down Arrow
Chapter 3: Local Port Operation
to open the Main dialog box.
Print Screen
.
Insert
29