Avocent DSR 1020 Guide D'installation Et D'utilisation page 104

94 DSR® Switch Installer/User Guide
Unbind from DSView 3 Server
This option enables you to clear the certificate sent by the DSView 3 software to the DSR
switch.
When a DSR switch is added to a server running DSView 3 software, a certificate is
downloaded from that server to the DSR switch automatically. If its system replicates
certificates, it will pass the certificate to the servers in that certificate replication system. All
servers in that system will then be allowed to access the DSR switch. All servers that are not
part of that system will be locked out.
There are two ways to remove the certificate from the DSR switch.
• The certificate will be automatically removed if you remove the DSR switch from the
DSView 3 software database. This enables you to move the DSR switch from one
certificate replication system to another.
• The Unbind option will also allow you to remove the certificate from the DSR switch,
enabling you to move the DSR switch from one certificate replication system to another.
After the Unbind option is used, any server running DSView 3 software will be able to
communicate with the DSR switch. All authentication server addresses will be cleared.
See the DSView 3 Installer/User Guide for more information on software security.
Firmware Management
This menu contains the Flash Download selection. For more information, see Flash Upgrades
on page 97.
Enable Debug Messages
This menu option turns on console status messages. Because this can significantly reduce
performance, you should only enable debug messages when instructed to do so by Avocent
Technical Support. When you are finished viewing the messages, press any key to exit this
mode.
Restore Factory Defaults
This menu option will restore all switch options to the default settings.
Reset Appliance
This menu option allows you to execute a soft reset of the DSR switch.
All manuals and user guides at all-guides.com