Publicité
Les langues disponibles
Les langues disponibles
30
DSR® Switch Installer/User Guide
Press the following keyboard commands in the Name, Port or Time column to move
through the list of target devices available to scan.
a.
Press
Alt+Down Arrow
b. Press
Alt+Up Arrow
c.
Press
Alt+Home
d. Press
Alt+End
5. In the Time column, type the number of seconds (from 3-255) of desired time before the
scan moves to the next target device in the sequence.
6. Move the cursor to the next line or press
remaining target devices to be included in the scan pattern.
7. Click OK to save your settings.
To remove a target device from the Scan list:
1. In the Scan dialog box, click the target device to be removed.
2. Press
Delete
-or-
Press
Shift+Delete
3. Click OK to save your settings.
For more on starting and stopping scanning, see Enabling or disabling Scan mode on page 40.
Setting local port Screen Saver options
You can use the Screen Saver dialog box to manage the screen saver inactivity time and test
the Screen Saver mode on the local port. If OSCAR Authentication has been enabled, after the
specified Inactivity Time elapses, the local port locks and remains locked until you press any
key or move the mouse. You will then need to log in and reselect a target device to continue.
To access the OSCAR interface Screen Saver dialog box:
1. If the OSCAR interface is not open, press
2. Click Setup - Screen Saver to open the Screen Saver dialog box shown in Figure 3.9.
All manuals and user guides at all-guides.com
to move the cursor down through the list of target devices.
to move the cursor up through the list of target devices.
to move the cursor to the first target device in the list.
to move the cursor to the last target device in the list.
.
to remove the selected target device and all entries below it.
and repeat steps 2-5 for each of the
Down Arrow
to open the Main dialog box.
Print Screen
Publicité
