Publicité
Les langues disponibles
Les langues disponibles
3. Select a country code and click OK to save your settings.
4. Reboot the Sun servers. After rebooting, each Sun server will request the country code
setting stored in the IQ module.
NOTE: If you wish to reboot the target devices by power-cycling them, you must wait 90 seconds before rebooting.
A soft reboot may be performed without waiting 90 seconds.
Configuring network settings
Use the Network dialog box to set the IP address, select an Ethernet mode or enable or disable
the Ping Response feature.
NOTE: Only Appliance Administrators can make changes to Network dialog box settings. Other users can still
access this dialog box, as well as the IP Setup dialog box, to view information, but they will not be able to make any
changes.
To set the Ethernet Mode:
1. If the OSCAR interface is not open, press
2. Click Setup - Network to open the Network dialog box shown in Figure 3.11.
Figure 3.11: OSCAR Interface Network Dialog Box
3. Select one of the available options in the Ethernet Mode section.
4. Click OK.
NOTE: You must reboot if you change the Ethernet mode. After you change the setting and click OK, the following
message appears: "Changing the Ethernet mode requires a reboot of the appliance. Do you want to reboot now, or
cancel the changes? Warning: Rebooting will disconnect ALL users!" You can then reboot by clicking Reboot, or
cancel the changes by clicking Cancel.
All manuals and user guides at all-guides.com
Chapter 3: Local Port Operation
to open the Main dialog box.
Print Screen
33
Publicité
