Avocent DSR 1020 Guide D'installation Et D'utilisation page 54

44 DSR® Switch Installer/User Guide
If your PS/2 keyboard or mouse locks up, you may be able to re-establish operation of these
peripherals by issuing a Reset command. The Reset command sends a hot-plug sequence to the
target device that causes the mouse and keyboard settings to be sent to the DSR switch. With
communication re-established between the target device and the DSR switch, functionality is
restored to the user.
To reset the PS/2 mouse and keyboard values:
1. If the OSCAR interface is not open, press
2. Click Commands - Reset PS/2. A message box displays requesting that you confirm the
reset.
3. In the message box, click OK.
a. A message appears indicating that the mouse and keyboard have been reset.
b. Click OK to close the message box.
-or-
Click X or press
mouse and keyboard.
Sending a ping request
To send a ping request:
1. If the OSCAR interface is not open, press
2. Click Commands to open the Commands dialog box.
3. Click Network Ping to open the Ping dialog box shown in Figure 3.24.
Figure 3.24: OSCAR Interface Ping Dialog Box
All manuals and user guides at all-guides.com
to exit without sending a Reset command to the PS/2
Escape
to open the Main dialog box.
Print Screen
to open the Main dialog box.
Print Screen