GE 21095 Mode D'emploi page 10

I
NSTALLING THE
1. Choose an area near an electrical outlet and telephone wall jack (RJ11C).
2. Plug the AC power supply into the electrical outlet and the DC connector
into the power jack on the back of the base.
CAUTION: Use only the ATLINKS USA, Inc. power supply 5-2605
(black) or 5-2606 (white) that came with this unit. Using other power
supplies may damage the unit.
3. Install the handset battery.
NOTE: You must connect the handset battery before use.
• Push down on the top of the battery compartment cover (located on
the back of the handset) and slide the cover off.
• Lift the battery pack and connect it's plug to the jack inside the
compartment.
PRESS DOWN
FIRMLY
NOTE: It is important to maintain the polarity (black and red wires) to the
jack inside the compartment as shown in the illustration.
• Slide the battery compartment cover back into place.
4. Connect the telephone line cord by plugging one end of the telephone
line cord into the jack on the back of the base and other end into a
telephone wall jack.
10
All manuals and user guides at all-guides.com
P
HONE
BATTERY
RED WIRE
BLACK WIRE