Stihl TS 480i Notice D'emploi page 32

English
Handle for the operator's right hand.
2 Throttle Trigger Lockout
Must be depressed before the throttle trigger
can be activated.
3 Throttle Trigger
Controls the speed of the engine.
4 Stop Switch
Switches the engine's ignition off and stops
the engine.
5 Starter Grip
The grip of the pull cord for starting the
engine.
6 Manual Fuel Pump
Provides additional fuel feed for a cold start.
7 Fuel Filler Cap
For closing the fuel tank opening.
8 Water Attachment
For connecting the water supply when wet
cutting.
9 Tensioning Nut
For tensioning the ribbed belt.
10 Adjusting Lever
For adjusting the position of the wheel guard.
11 Abrasive Wheel
The cutting attachment, either composite or
diamond.
12 Front Thrust Washer
Distributes clamping pressure of mounting nut
evenly over abrasive wheel.
13 Wheel Guard
Covers a portion of the wheel, reducing the
risk of injury from kickback and inadvertent
contact by the operator and captures and re-
directs sparks, cutting debris or wheel frag‐
ments.
14 Reinforcing Element
Protects the wheel guard against excessive
wear.
Reduces the wear of the wheel guard.
15 Muffler
Reduces engine exhaust noises and diverts
exhaust gases away from operator.
16 Spark Arresting Screen
Designed to reduce the risk of fire from
exhaust sparks.
17 Front Handle
Handle for the left hand.
18 Decompression Valve
Releases compression to make engine start‐
ing easier - when activated.
32
19 Spark Plug Boot
Connects the spark plug to the ignition lead.
20 Water Control Panel
When the engine is running, it is possible to
activate / deactivate the electronic water con‐
trol and adjust the water flow.
21 Cover for Control Unit
Covers and protects the control unit.
22 Filter Cover
Covers and protects the air filter element.
Clutch (Not illustrated)
Couples engine to the belt pulley when the
engine is accelerated beyond idle speed.
Belt Pulley (Not illustrated)
The mechanism that drives the ribbed belt
and the abrasive wheel.
Anti-Vibration System (Not illustrated)
The anti-vibration system includes a number
of elements designed to reduce the transmis‐
sion of vibration created by the engine and
cutting process to the operator.
24 Specifications
24.1 EPA / CEPA
The Emission Compliance Period referred to on
the Emissions Compliance Label indicates the
number of operating hours for which the engine
has been shown to meet Federal emission
requirements.
Category
A = 300 hours
B = 125 hours
C = 50 hours
24.2 STIHL Injection
Control unit with characteristic-curve-driven igni‐
tion timing adjustment
load-dependent, characteristic-curve-driven fuel
injection
24.3 Electronic water control
The electronic water control allows the optimum
water quantity to be supplied to the abrasive cut‐
ting wheel. No water is supplied when the tool is
idling.
24.4 Engine
STIHL single-cylinder two-stroke engine
24 Specifications
0458-753-8221-D