Stihl TS 480i Notice D'emploi page 18

English
► Turn the tensioning nut (2) counterclockwise
with the combination wrench –
approx. 1/4 turn, as far as it will go = 0
8.1.4 Removing the V-belt guard
► Unscrew the screw (1) – screw (1) is secured
on the V-belt guard (2) to prevent loss
► Raise the V-belt guard (2) slightly and pull it
off to the front
► Remove the V-belt (3) from the front pulley (4)
18
2
1
4
3
8 Assembling the cast arm and guard
8.1.5 Removing the "cast arm with guard"
1
► Remove the nuts (1)
► Remove the "starter cover with rewind
starter" (2)
► Remove the "cast arm with guard" (3) from the
studs
8.1.6 Preparing the "cast arm with guard" for
outboard mounting
► Unscrew the stop pin (1)
4 5
3
1
2
1
1
1
3 2
0458-753-8221-D
A