Stihl TS 480i Notice D'emploi page 19

8 Assembling the cast arm and guard
► Turn the guard so that it is in the position
shown (see picture)
► Screw in and tighten the stop pin (1)
► Move the adjusting lever (2) to position A
► Screw in the bolt (3) and tighten up
► Remove screw (4) from the limit stop (5)
► Pull off the limit stop (5)
4 5
► Turn the "cast arm with guard" so that the
guard is on the outboard side
► Insert limit stop (5) – align the hole in the limit
stop with the hole in the cast arm
► Screw in the bolt (4) and tighten up
► Insert the square nut into the guide in the
guard and hold it in place
► Screw in the shorter banjo bolt (6) and washer
at the adjusting lever and tighten up with the
combination wrench
8.1.7 Mounting "cast arm with guard" –
guard on the outboard side
1
2
3
4
0458-753-8221-D
6
1
2
1
2
► Press the oblong holes (1) in the "cast arm
and guard" on to the studs (2), guiding the rib‐
bed V-belt over the front pulley
NOTICE
The belt action must run smoothly.
► The belt tensioner (3) must sit close to the
lug (4)
2
5
6
► Fit the "starter cover with rewind starter" (5)
over the studs (2)
► Tighten up the nuts (6) by hand
7
8
► Push the V-belt guard (7) into place
► Screw in the bolt (8) and tighten up
8.1.8 Connecting the water connection
3
1
2
1
► Insert the longer banjo bolt (1) through the
connector (2) of the water attachment –
observe the position of the connector
► Insert the square nut into the guide in the
guard and hold it in place
English
2
2
6
6
19